版权说明 操作指南
首页 > 成果 > 详情

输电导线微风振动传感器结构设计与应用性能研究

认领
导出
Link by 中国知网学术期刊 Link by 维普学术期刊 Link by 万方学术期刊
反馈
分享
QQ微信 微博
成果类型:
期刊论文
作者:
谢妍;付宇豪;徐芬;李牧
作者机构:
武汉轻工大学电气与电子工程学院
[付宇豪] 华能武汉发电有限责任公司
[李牧; 徐芬] 国网电力科学研究院武汉南瑞有限责任公司
[谢妍] 武汉轻工大学
语种:
中文
关键词:
光纤光栅;微风振动传感器;悬臂梁;应用性能
关键词(英文):
fiber bragg grating(FBG);breeze vibration sensor;cantilever beam;application performance
期刊:
武汉轻工大学学报
ISSN:
2095-7386
年:
2018
卷:
37
期:
3
页码:
90-97
机构署名:
本校为第一机构
院系归属:
电气与电子工程学院
摘要:
输电线路运行时,由于受风的作用,导线时刻处于振动状态,高频微幅的微风振动使得输电线沿线产生不同程度的动弯应力,从而可能导致导线、地线出现疲劳断股的现象。目前,采用能量平衡法计算微风振动的方法被广泛研究,但其数值分析方法的复杂性导致其无法较好地应用于现场实际。笔者首先对光纤光栅微风振动传感器的悬臂梁式封装方式进行改进。为避免能量平衡法和传递矩阵法产生的计算误差,采用悬臂梁原理直接测量导线离线夹出口处的导线振动振幅,将其作为衡量导线动弯应变的指标来反映微风振动情况,在此基础上,给出相应的安装夹具结构图。为测试此光纤光栅微风振动传感器的工作特性,分别进行了实验室...
摘要(英文):
When the transmission line is running, the conductor is always in the vibration state due to the action of wind. The high-frequency and micro wind vibration modes of transmission lines causes different degrees of dynam-ic bending stress along the transmission line and may lead to fatigue and strand breakage of wires and ground wires. At present, the energy balance method is widely used to calculate the vibration of the breeze. However, the com-plexity of its numerical analysis makes it unable to be applied to the field practice. In this paper, the cantilever beam packaging method of FBG micro ...

反馈

验证码:
看不清楚,换一个
确定
取消

成果认领

标题:
用户 作者 通讯作者
请选择
请选择
确定
取消

提示

该栏目需要登录且有访问权限才可以访问

如果您有访问权限,请直接 登录访问

如果您没有访问权限,请联系管理员申请开通

管理员联系邮箱:yun@hnwdkj.com